Zoom Modems

By admin in : Routers // Feb 17 2010

The information below will assist you in setting up your Zoom X4 Modem with iCU2:

On iCU2:

Go into Tools – Options – Ports
Switch from Direct to Network

In “normal” and “network” areas make sure both areas say:
Primary: TCP 2000
Secondary: TCP 2001

Also take note of your “IP address”

You then need to log into the Virtual Server Area of the modem’s admin section and setup virtual server rules/entries that send:
TCP 2000 to the IP address you took note of
TCP 2001 to the IP address you took note of

From what I can see (at http://www.adslguide.org.uk/hardware/reviews/2003/q2/zoom-x4.asp), once into the Virtual Server Area, you should make two entries that look simliar to this:

Remember to click “add this setting” after making entry 1, and then click “add this setting” again after adding entry 2.

If you have any problems/questions regarding this, please contact Zoom Support for help with their Modem.

Comments are closed.